Rectifier Rectifiers Wind
Rectifier Rectifiers Wind
 |
 80 AMP RECTIFIER WIND TURBINE GENERATOR PMA 3 PHASE AC to DC  US $17.39
|
 80 AMP 3 THREE PHASE RECTIFIER WIND TURBINE GENERATOR US $15.98
|
 10pcs 8 AMP 45 VOLT Schottky BLOCKING DIODES Wind Solar US $14.75
|
 75 AMP THREE 3 PHASE rectifier rectifiers WIND US $12.45
|
 4 LOT 80A THREE PHASE RECTIFIER WIND TURBINE GENERATOR US $57.98
|
 LARGE 0375 QUICK CONNECT FOR RECTIFIER WIND TURBINE GENERATOR 3PHASE AC to DC US $2.59
|
 80 AMP RECTIFIER WIND TURBINE GENERATOR PMA AC to DC US $19.49
|
 75 A AMP THREE 3 PHASE bridge rectifier WIND Hydro US $12.45
|
 5 LOT 35 AMP 3 THREE PHASE BRIDGE RECTIFIER WIND DC AC US $29.98
|
 10 LOT 80A THREE PHASE RECTIFIER WIND TURBINE GENERATOR US $129.98
|
 20pcs 3 AMP 40 VOLT Schottky BLOCKING DIODES Wind Solar US $15.25
|
DIY Vertical Wind Turbine - DIY Green Energy
Aside from the sun, another renewable energy source that we can get from our planet is wind energy. Building a DIY vertical wind turbine will enable you to harness this free and ecologically friendly energy source. Paying the electricity bill should be a breeze if you have one mounted onto your rooftop.
Click Here For DIY Green Energy Instant Access Now!
Making a DIY vertical wind turbine is practically an easy project. A basic wind turbine, provided with a steady wind current can produce about fifty kilowatt hours of electricity per month. Built mostly of plywood, magnets and aluminum this turbine works well for wind speeds of six to twenty miles per hour.
Begin constructing your wind turbine by cutting carefully teardrop shapes from plywood. Next you connect them by using four foot steel rods. Then you cover them with aluminum and your wings are done. Now you begin building the alternator. The alternator converts wind energy into electricity. You can build one by gluing multiple magnets on two steel discs. Make a disc out of plywood and tape copper wire coils on it, and then slide all three discs into the shaft. Now you attach the other parts of the wind turbine. On a rectangular frame, clamp both ends of the shaft. Next is to weld the wing's arms under the alternator. Also weld the wings to the steel disc at the turbines top. Then attach cables to the frame arms and use sandbags to stabilize them.
The last step is to wire a rectifier to the alternator. Connect the batteries to convert the power to DC voltage. It takes about four to six hours to charge eight batteries fully, and then it is ready to power the house.
Using clean and renewable energy will not just save you money; you will also help save the environment. You should start building a DIY vertical wind turbine and start enjoying its benefits. Begin living green today.
Click Here For DIY Green Energy Instant Access Now!
About the Author
This author writes about Guide To Solar Power Review and Make Solar Panels At Home